Charging The Battery; Installation Of The Boundary Wire - Husqvarna Robotic Lawn Mowe Operator's Manual

3.3 Charging the battery

The Automower is supplied with an uncharged battery.
As soon as the charging station is connected, it is
possible to charge the mower.
1. Set the main switch to the OFF position.
2. Place the Automower in the charging station to
charge the battery while you are laying the
boundary wire.
From an uncharged state the battery takes about
1 1/2 to 2 1/2 hours until it is fully charged.
IMPORTANT INFORMATION
Automower cannot be used before the
installation is complete.

3.4 Installation of the boundary wire

The boundary wire can be installed in one of the
following ways:
• Securing the wire to the ground with staples.
It is preferable to staple down the boundary cable,
if you want to make adjustments to the boundary
wire during the first few weeks of operation.
• Bury the wire.
It is preferable to bury the boundary wire if you
want to dethatch or aerate the lawn.
If necessary both methods can be combined so one
part of the boundary wire is stapled down and the
remainder is buried.
Best position for the boundary wire
The boundary wire should be laid so it:
• Forms a loop around the working area for
Automower. Only an original boundary wire must
be used. This is tinned and has a high quality
insulation to withstand the dampness in the
ground.
• Is a maximum of 500 metres long.
• Maintains a maximum distance of 3 metres from
Automower in the entire working area.
3. Installation
3012-385
Automower from 23
™