Husqvarna Robotic Lawn Mowe Operator's Manual page 29

Laying out the boundary wire
Run the boundary wire around the working area, but
wait before connecting the wire to the charging
station.
When you run the boundary wire, remember the
boundary wire may need to be adjusted later.
Accordingly, run:
• A few extra metres of wire, at the beginning and
end, close to the charging station.
• A few extra metres of wire about every
30 metres around the entire loop.
All extra wire should be laid in tight, parallel
loops. If staples are used, the parallel loops
should be placed under the same staple.
IMPORTANT INFORMATION
Extra wire must not be placed in coils outside
the boundary wire. This can disrupt the
Automower.
Tip!
Use the supplied measurement gauge as a guide
when you lay out the boundary wire. This helps you to
easily set the correct distance between the boundary
wire and the boundary/obstacle.
If you intend to staple down the boundary wire:
Tip!
• Mow the lawn where the wire is to be laid
using a normal lawn mower or a trimmer. It will
then be easier to lay the wire close to the ground
and the risk of the mower cutting the wire off is
reduced.
• Make sure to lay the boundary wire tight to the
ground and secure the staples close together. The
wire must generally lie close to the ground so as
not to be cut off before the grass roots have grown
over it.
• Use a hammer to knock down the staples in the
ground.
3. Installation
3012-221
3012-138
3012-281
Automower from 29
™