Linking The Automower To The Charging Station; Installation Of The Guide Wire - Husqvarna Robotic Lawn Mowe Operator's Manual

3. Installation
3.7 Linking the Automower to the
charging station
1. Open the control panel cover by pressing the
STOP button.
2. Place the Automower in the charging station.
3. Set the main switch to the ON position.
A start-up sequence begins when the Automower
is started for the first time. The following is
requested: Language, time format, correct time,
date format, date, and four-digit PIN code. All
combinations except 0000 are permitted.
When you have chosen a PIN code with the
Automower placed in the charging station, the mower
and charging station are then linked to each other.

3.8 Installation of the guide wire

The guide wire is an extra wire that is laid from the
charging station, out towards a remote part of the
working area or through a narrow passage and is then
connected to the boundary wire. The same wire used
for the boundary wire is also used for the guide wire.
In similarity to the boundary wire, the guide wire can
either be stapled down or buried.
When a guide wire is installed, the Automower can also
be set to follow the guide wire out from the charging
station using the function Follow loop out (3-2-1), see
page 53.
Need of a guide wire
The guide wire may be necessary in installations
where the search methods Irregular and Follow loop in
are not adequate for the mower to quickly and easily
find the charging station.
A few examples of installations where a guide wire is
recommended follow below:
• Narrow passages.
In passages where the distance between the
boundary wires is less than 3 metres, it is
recommended to install a guide wire through the
passage. This is a better solution than allowing
Automower to follow close to the boundary wire by
setting a low Corridor width value.
34 Automower from ™
3012-385
3012-408