Step 3: Performing Manual Regen; Adding The Pelican Logo Sticker - Pelican Advantage Series Owner's Manual

Advantage Series Salt Based Water Softeners / Nitrate Series Salt
Based Filter System / Tannins Series Salt Based Softeners
Note 2: For Pelican PT3/PT6 Tannin Filter, set to 6 (days override) instead of 14 days.
Note 3: This number is determined by the specific softener purchased. The first two numbers in the
product title "XX,000 Grain Softener" will be selected as "XX". For example, the 32,000 Grain Softener
would have the number "32" selected and the 80,000 Grain Softener would have "80" selected. If you are
unsure of the specific grain softener you have purchased, contact customer service for additional help.

Step 3: Performing Manual Regen

!IMPORTANT!
You will not be able to use water in the house for approximately 2 hours during the Regen process.
1. Press and hold the EXTRA CYCLE button for 5-7 seconds.
Note: Gears will make noise and water will start to flow.
2. Allow the system to EXTRA CYCLE for 2 hours.
Your manual regen cycle is complete and the tank is ready for use.

Adding the Pelican Logo Sticker:

1. Peel back plastic to remove it from the tank.
2. Place sticker in the desired location on the tank.
© 2011 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
— Rev G
Page 11
www.pelicanwater.com
(877) 842-1635