Advantage Series Salt Based Water Softeners / Nitrate Series Salt
Based Filter System / Tannins Series Salt Based Softeners
Installation
Install Electronic Head
Incoming
Water
Supply
Figure 3
Notice:
Follow the raised black arrows on the head of the Mineral.
1. Level the Pelican Mineral Tank.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line from the In-Line Injection Port
and choose the appropriate fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
Part
Description
1" PVC Tail Adaptor for
Electronic Head Bypass
Note: The fitting above is designed with a ¼" give to allow for proper pipe alignment. It will not leak and
is intended to have some flexibility.
3. Remove the gray cap from the top of the Mineral tank.
4. Screw the Electronic Head onto the tank hand-tight.
© 2011 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Wall
Safety Valve
Holding Tank
Brine Tank
Qty.
2
Outgoing
Water to
Discharge
Line
Mineral Tank
www.pelicanwater.com
(877) 842-1635
— Rev G
Page 7
House
Electronic
Head