Care And Cleaning; Sediment Filter; Replacing The Sediment Filter; Chemical Injector Pump - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener

Care and Cleaning

Sediment Filter

It is recommended that the Sediment Filter be replaced every 6-9 months depending on the amount of
sediment present in the water supply. If the system has been working properly and the pressure is
slowing, it may be time to change the Sediment Filter. Check the Sediment Filter and replace if necessary.

Replacing the Sediment Filter

Blue Pre-Filter Housing
1. Turn off the main water supply to the Pre-Filter System and bypass all tanks.
2. Run a faucet (cold water) inside the house to relieve the pressure.
3. Unscrew the Blue Pre-Filter Housing clockwise using the supplied Pre-Filter Wrench.
4. Remove the existing Sediment Filter and discard.
5. Remove the O-Ring and wipe the groove and O-Ring clean. Lubricate the O-Ring with a coating of
clean silicone grease. Replace O-Ring and press the O-Ring down into the groove with two fingers.
Note: This step is important to ensure the proper filter seal. Make sure the O-Ring is seated level
in the groove. If the O-Ring appears damaged, stretched, or crimped it should be replaced at this
time.
6. Place a new Sediment Filter onto the Stand Pipe in the Blue Pre-Filter Housing.
7. Screw the Blue Pre-Filter Housing onto the Pre-Filter Cover.
8. Turn on main water supply slowly to allow the Pre-Filter System to fill with water and put tanks
back in service, out of bypass.
9. Check for leaks.

Chemical Injector Pump:

1. Change every six months (Kit A - part number P-SDP-A) - 2 o-rings and dosage piston. One extra
Kit A is included with your original purchase.
2. Change every year (Kit C- part number P-SDP-C) - 2 o-rings, dosage piston, and shaft.
Note: Spare kits for replacement purposes can be obtained by calling your customer service
representative at Pelican Water.
Solution Tank Refill — Chlorine
1. Check the level of the Solution Tank once per month. Do not let the liquid in the tank fall below
¼ full.
2. Fill the tank with 9 cups of household bleach and 35 gallons of treated water (water that has gone
through your filtration system). Replace the cap.
© 2013 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Pre-Filter Cover
Page 23
Sediment Filter
O-Ring
Stand Pipe
www.pelicanwater.com
(877) 842-1635
Rev P