Whole House Water Filter Tank Installation - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
6. Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.
7. Connect the outgoing water supply to the outlet side of the Bypass Valve.
8. Firmly press one end of the discharge PVC Tubing Drain Line onto the barbed nose, and secure the
other end of the line to a drain.

Whole House Water Filter Tank Installation

1. Level the Pelican Whole House Water Filter.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
Wall
Incoming
Water
Supply
Chemical
Pre-Filter
Injector
Pump Tubing
Solution Tank
Figure 9
2. Determine the size and material of your incoming water supply line from the Whole House Iron &
Manganese Filter and choose the appropriate plumbing required to adapt to the 1" Male NPT
Assembly.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 3: Bypass Valve Fittings
Note: The fitting below is designed with a ¼
is intended to have some flexibility.
Part Description
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male NPT
Assembly (2): O-Rings (2), Split Rings
(2), and Connectors (2)
© 2013 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Chemical Injector
Pump
Electronic
Head
Whole House
Iron & Manganese Filter
give to allow for proper pipe alignment. It will not leak and
"
Qty.
1
bag
Discharge
Line
Whole House
Water Filter
Rev P
Page 14
Wall
Spigot
(optional)
Outgoing
Water to
House
Salt Free Water
Softener/Conditioner
www.pelicanwater.com
(877) 842-1635