Rear Panel; Label - NETGEAR R6300v2 User Manual

on. If this LED is off, the wireless radios are turned off and you cannot connect wirelessly
to the router.
• WPS button. You can use this button to use WPS to add a wireless device or computer
to your wireless network. The Wireless LED blinks blue when the router is trying to add
the wireless device or computer. The LED stays solid blue when wireless security is
enabled in the router.

Rear Panel

The rear panel has the connections and buttons shown in the following figure.
USB 3.0
port
Figure 3. Router rear panel
The Reset button restores the factory settings. See

Label

The label on the bottom of the router shows the login information, MAC address, and serial
number.
Default access information
Preset WiFi
password
Figure 4. The label shows unique information about your router
R6300v2 Smart WiFi Router
Ethernet Internet
port
LAN ports 1–4
Hardware Setup
10
Reset
button
Factory Settings on page 132.
Serial number and
MAC address
Power connector
Power On/Off