NETGEAR R6300v2 User Manual page 82

3. Click the Add Service button.
4. In the Service Name field, type a descriptive service name.
5. In the Service User list, select Any, or select Single address and enter the IP address of
one computer.
• Any (the default), allows any computer on the Internet to use this service.
• Single address restricts the service to a particular computer.
6. Select the service type, either TCP or UDP or TCP/UDP (both). If you are not sure, select
TCP/UDP.
7. In the Triggering Port field, enter the number of the outbound traffic port that will open the
inbound ports.
8. Enter the inbound connection port information in the Connection Type, Starting Port, and
Ending Port fields.
9. Click the Apply button.
The service appears in the Port Triggering Portmap table.
10. Make sure that you enable port triggering so that the service that you added will be used.
R6300v2 Smart WiFi Router
Security
82