Set Up The Netgear Usb Control Center - NETGEAR R6300v2 User Manual

Set Up the NETGEAR USB Control Center

The first time you access the utility, you are asked to select the printer.
• When a USB printer is detected and connected automatically during the initial setup, you
have to disconnect the printer and wait for the prompt asking you to click Connect.
• You might be asked to install the driver for this printer. After the driver is installed, the
printer status changes to Available.
To set up the NETGEAR USB Control Center:

1. On each computer on your network that shares the USB printer, launch the NETGEAR
USB Control Center the same way you launch any application program on your
Windows or MAC computer.
2. Select the printer and click the Connect button.
Once the connection is established, the status changes to Manually connected by xxx.
3. Click the Disconnect button.
The status changes to Available.
R6300v2 Smart WiFi Router
ReadySHARE Printer
66