Installer Setting-Dry Contact Mode Setting; Installer Setting - Zone State - LG PQRCVSL0 Owners & Installation Manual

Installation instruction

Installer Setting-Dry Contact Mode Setting

Dry contact function is the function that is possible to use only when dry contact equipment is
separately purchased/setup.
▶
What is Dry Contact?
Like hotel card key and body perception sensor, it is the signal of the point of contact when using
air-conditioner by interlocking.
• Please refer to dry contact manual for more details.
20 New Wide Wired Remote Controller
1 If pressing button long for 3
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
2 If pressing button repeatedly, it moves to
remote controller dry contact mode setup
menu as picture below.
3 Select Dry contact setting by
pressing button.
(00 : Automatic, 01 : manual)
Function Code Dry Contact
setting value
4 Press button to save.
5
Pressing button will exit settings mode.
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.

Installer Setting - Zone State

It is the function to setup indoor unit's wind flow to variable or fixed.
- Variable : Comp ON, setup airflow. Comp OFF, weak wind
- Fixed : Comp ON, setup airflow. Comp OFF, setup airflow
Installation instruction
1 If pressing button long for 3
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
2 If moving to ceiling height selection menu by
pressing button, it indicates as picture
below.
3 Select Zone State rate fixing mode by
pressing button.
(01: Variable, 02: Fixed)
Function Code Zone State
fixing mode
4 Press button to save.
5
Pressing button will exit settings mode.
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
Ownerʼs & Installation Manual 21