Installer Setting-Dry Contact Mode Setting - LG PQRCUSA0 Owners & Installation Manual

Installation instruction

Installer Setting-Dry Contact Mode Setting

This function allows the Dry contact-indoor unit operate under Auto Run mode or Manual mode with
remote controller.
* Please refer to dry contact manual for more details.
20 Wide Wired Remote Controller
1 Press button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2 Repeat pressing button to select
Function code 09.
Function Code Dry Contact setting value
Ex) Setting Dry Contact Mode 'ON'
3 Select Dry contact setting by
pressing button.
(00: OFF, 01: ON)
4 Press button to save or release.
5
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
Installer Setting-Zone State Setting
This function is only available on some products.
It is possible to setup Variable or Fixed option for Zone State of indoor. The initial setting is 'Variable'
Installation instruction
1 Press button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2 Repeat pressing button to select
Function code 11.
Function Code Zone State fixing mode
Ex) Setting Zone State as 'Fixed'.
3
Select Zone State rate fixing mode by
pressing button.
(01: Variable, 02: Fixed)
4 Press button to save or release.
5 Press button to exit or
system will automatically exit
after 25 seconds without any
input.
Owner's & Installation Manual 21