Cleaning The Brewing Unit - SEVERIN S2+ One Touch Instruction Manual

GB
fig. 14: Removing the cover of the brewing unit
8.3

Cleaning the brewing unit

In addition to an integrated cleaning program, the device also offers you the
opportunity to clean the brewing unit manually. For this, the brewing unit can
be removed as follows:
1. Switch the device off and disconnect the plug.
2. Remove the water tank and shake out the remaining water.
3. Open the door of the brewing unit on the back side of the device by
pressing down on the tabs with your thumbs and pulling towards you
(Fig. 14).
4. Remove the brewing unit door completely.
The brewing unit is now visible.
Â
5. Pull the red lever of the brewing unit upwards and pull the brewing unit
carefully downwards at an angle out of the machine (Fig. 15).
62
1.
2.
1.
2.
fig. 15: Pulling out the brewing unit
6. Clean the brewing unit under running water.
CAUTION!
Incorrect handling of the brewing unit can cause
damage to the brewing unit.
– Do not take the brewing unit apart or adjust it.
– Make sure that the locking lever of the brewing
unit is open when you insert it.
– Push the brewing unit carefully in from bottom
to top.
7. Insert the brewing unit into the machine from behind and push it in as far
as it goes (Fig. 16).
8. Press the red lever of the brewing unit down. If the lever does not move,
check the position of the brewing unit again and re-insert it.
1.
2.
fig. 16: Inserting the brewing unit
Version 3 2012-08