Table of contents 7.3. Changing device settings ............ 52 1. General information ..........38 1.1. Greeting ................38 7.3.1. Language ..............52 1.2. Notices concerning the operating manual ......38 7.3.2. Water hardness ............53 7.3.3. Water filter ..............53 2.
Important notes for your safety are marked in a special fashion. Be sure to Greeting follow these instructions to avoid accidents and damage to the device: Dear Customers, we are pleased that you have selected a SEVERIN fully automatic coffee maker. Dive into the enjoyable world of coffee and milk WARNING! specialities.
Fill the water tank of the device only with cold, fresh non carbonated water, • Make sure that the power cable is not bent or pinched and that the power never with milk, instant powders, syrups or other flavouring substances and cable and the device do not come in contact with heat sources (e.g.
Page 5
• Check the device for damage prior to every use. In the event that you detect damage due to transport, immediately contact the dealer where you have purchased the device or SEVERIN customer service. Never operate a defective device. Never operate a device that has fallen down.
3. Technical data 4. Overview Scope of delivery Voltage 220–240 V~, 50/60 Hz The device's scope of delivery includes: Output/power consumption 1500 W • Your fully automatic coffee maker Safety test CE, CB, EMC • Water filter Pump pressure (max.) 15 bar •...
Device Item Designation Explanations On/off switch Overview Water filter with inser- To improve the water quality. tion aid Water tank For adding drinking water. Bean container cover Bean container signal Lights up if the supply of beans is get- lamp ting too low.
1. Plug the mains plug into the outlet. display. 2. Switch the device on with the on/off switch. The display shows the text "SEVERIN“ and then: Â PLEASE SELECT LANGUAGE 3. Turn the e-Select until the desired language is shown and confirm it by pressing the e-Select.
Page 9
As soon as the rinsing procedure is complete, the display shows water. SEVERIN recommends the use of a water the "Beverage selection" view. The device is now ready for opera- filter for high water quality starting with 10 °dH.
1. Switch the device on with the on/off switch. strong coffee The display shows the text "SEVERIN“ and then: Â individually-set quantity of beans RINSING The rinsing of the brewing unit is complete as soon as "Beverage Preparation with ground coffee selection“...
The device is operated using the e-Select and the control buttons. 2. Fill the bean container with coffee beans (Fig. 4). • Use e-Select to select a beverage: prepare it by pressing. 3. Close the cover of the bean container. - The e-Select lights up steady white if the device is waiting for an input 6.3.1 Preparing coffee or espresso from you.
(Fig. 5). enough beans in the bean container and enough water in the water tank. 3. By turning the e-Select, select Also place a container filled with milk (e.g. SEVERIN milk cooler) next to the CAPPUCCINO LATTE MACCHIATO device.
Page 13
fig. 6: Connecting the milk tube fig. 7: Turning over the powder dosing chamber The display shows a bar with the set quantity in "ml". Â NOTE! The coffee dispensing stops automatically, but can also be To prepare the coffee speciality with your own stopped by pressing e-Select.
Preparing coffee with coffee powder 8. To make changes to the liquid quantities while drawing, turn the e-Select as described in the sections ►"6.3.1 Preparing coffee or espresso" and You can also prepare a coffee speciality with coffee powder. This is espe- ►„"6.3.2 Preparing coffee-milk specialities".
fig. 8: Setting the grinding fineness 7. Individual settings CAUTION! If the fineness setting is moved without grinding Setting the grinding fineness coffee beans, the grinder can be damaged. The grinding fineness affects the taste of the coffee. Select the grinding fine- –...
5. Now set the fineness of the beans on the grinder regulator. To do this, Cappuccino/Latte macchiato press the grinder regulator down and turn it (Fig. 8). Quantity Coffee 20 – 250 ml • to the right in order to set a high fineness. Quantity Milk 10 –...
7.2.2 Making personal settings quickly NOTE! (Quick Select) – The total fill quantity of the cup for beverages You can also make the settings temporarily before the preparation: prepared with milk consists of the coffee quan- tity plus the milk/milk froth quantity! Take this 1.
NOTE! 7.3.2 Water hardness SEVERIN recommends the use of a SEVERIN water filter for high water quality. The water filters Select the water hardness according to the water hardness in your house- are effective for approx. 4 to 8 weeks before they hold.
2. Then select the For a short while, the display shows the note: Â AUTO POWER-OFF DEVICE SET TO FACTORY DEFAULTS menu option. All settings are reset. You must now perform all the basic settings again The display shows the currently-set time for the automatic power- Â...
8. Maintenance at the latest every 2 months In order to enjoy your device for a long time and indulge in consistently good Change water filter coffee, you must clean the device regularly. Following is an overview of all (►"8.2.6 Changing the water filter") necessary cleaning activities.
fig. 9: Removing the coffee-milk fig. 10: Removing the milk foaming fig. 11: Assembling the drip tray dispenser nozzle CAUTION! NOTE! If you do not run the cleaning program right away, Milk is a food that can spoil. For your health, you a warning symbol appears on the display as a re- should therefore always clean the milk unit as soon minder that you must still start a cleaning program.
6. Remove the grounds container and empty the coffee grounds. The display shows: Â RINSING 7. Clean both parts and the cup tray with clear water and a mild detergent. The rinsing is complete as soon as "Beverage selection" appears 8.
PLEASE PLACE MILK TUBE IN CLEANING LIQUID 8.2.4 Cleaning program 3. Fill a container with 200 ml warm water and 20 ml SEVERIN milk sys- The device has a cleaning program with which the coffee system can be tem cleanser. (mixing ratio 1:10) rinsed and cleaned intensively with a cleaning tablet.
8. Press the e-Select to continue. NOTE! The display shows: Â – The descaling process can take as long as 30 DESCALING minutes. 9. As soon as the command – No warranty is made for damage that is due to EMPTY DRIP TRAY devices which have not been descaled regularly.
Page 26
fig. 12: Inserting the insertion aid on water filter fig. 13: Inserting the water filter 2. Then select the The filter change is complete as soon as the "Beverage selection" Â view is displayed again. WATER FILTER menu option and press the e-Select. The display shows: Â...
fig. 14: Removing the cover of the brewing unit fig. 15: Pulling out the brewing unit fig. 16: Inserting the brewing unit Cleaning the brewing unit 6. Clean the brewing unit under running water. In addition to an integrated cleaning program, the device also offers you the CAUTION! opportunity to clean the brewing unit manually.
– Never repair a defective device yourself. In CAUTION! case of a technical defect, contact SEVERIN There is a danger of damage to the device if customer service. objects fall into the bean feed. – Switch the device off before starting cleaning.
Page 29
Display Cause Remedy Display Cause Remedy There is not enough Clean the water tank and There is too much Clean the brewing unit (►"8.3 WATER SUP- TOO MUCH water in the brewing especially its water discharge coffee in the brewing Cleaning the brewing unit").
10. Disposal Display device information For questions to customer service in case of a fault, you can display various CAUTION! device information on the display. Incorrect disposal can cause environmental dam- This is how to display device information: age. 1. Press the menu button for at least 3 seconds and use the e-Select to –...
11. Tips for perfect coffee enjoyment Situation Situation What kinds of coffee can I use? All types of coffee that are not My espresso tastes sour. Use a different type of coffee. treated after roasting (e.g. with Reduce the strength of the coffee sugar).
12. License provisions Situation FreeRTOS This product contains software which is linked to FreeRTOS V6.0.1 - Copy- What type of milk is best for froth- Types of milk with a high protein right (C) 2009 Real Time Engineers Ltd. FreeRTOS V6.0.1 is licensed by the ing? content.
Page 33
* Neither the name of the copyright holders nor the names of contributors may be used to endorse or promote products derived from this software without specific prior written permission. THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS “AS IS” AND ANY EXPRESS OR IMPLIED WARRAN- TIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.