Appendix B - Station Select Protection - Seastar Solutions Optimus 360 Operating Instructions & User Manual

© 2012 SeaStar Solutions
AppENDIX b
Station Select Protection
Station Select Protection prevents accidental switching between
control stations on multi-stationed boats. If turned on, a change of
control stations requires that control head buttons be pressed in a
specific sequence.
operation
If Station Select Protection is turned on, to select or change stations
use the following button sequence:
•
Go to the station you wish to make active
•
Press the Take Command button
•
Press the Take Command button again
•
Press the Neutral or 'N' button
•
Press the Take Command button
•
The station will go active (blue light on solid) if the levers are
matched with the originally active station.
•
If the blue light flashes, match the levers with the originally active
station and the blue light will go solid.
untIL the bLue LIGht IS on SoLId, the orIGInaL actIve StatIon
retaInS controL of the boat.
on muLtIpLe heLm StatIon boatS, aLL SteerInG heLmS are
actIve when the optImuS epS IS turned on. thIS IS the Same
you wouLd fInd on a conventIonaL hydrauLIc SteerInG
SyStem. StatIon SeLect onLy appLIeS to the controL head.
Optimus 360 User's Manual, Rev. C
b-1