Identification - Seastar Solutions Optimus 360 Operating Instructions & User Manual

Figure 5-1.
5-2

5.1 Identification

take command button and Lamp:
Used to take command of shift and throttle with a control head.
to take command with a control head:
• Put control levers in neutral and press take command. (If you are
transferring control from a joystick, it must also be in the neutral
position.)
• The adjacent lamp signals the transfer status as follows:
Steady blue – station is active and in control of shift and throttle.
Flashing blue – station transfer from one station to another is
underway. You have five seconds to match the control lever positions
with those of the active station to complete the transfer.
Lamp off – station is inactive
Note: If the lamp does not come on when you press take command,
Station Protection may be enabled. See Appendix B.
© 2012 SeaStar Solutions
enGIne trIm controL:
Provides simultaneous trim control of all engines.
Lever poSItIon
IndIcatorS
neutraL IndIcator LampS:
These lamps have four states:
Steady green – engine is in neutral
Fast flashing green – Neutral Throttle Warmup
is engaged
Slow flashing green – Trolling Mode is engaged
Flashing red – System fault
IndIcator dImmInG feature:
When the control head is active, pressing
take command repeatedly will cycle through
five available indicator brightness levels.
Optimus 360 User's Manual, Rev. C
See section 10.