Maserati Quattroporte Automatic Owner's Manual page 96

M139_UM_ing.book Page 96 Friday, September 5, 2008 8:19 AM
Should the so programmed HomeLink
not activate the system to be
controlled, this may be due to the fact
that this system is controlled by a
remote control with an alternate code.
An alternate activation code can be
recognised in the following ways:
– Consulting the instruction manual
provided with the device to be
controlled.
3
– Despite the fact that the HomeLink
programming procedure has been
carried out correctly, the HomeLink
function does not activate the
device.
– Holding the dedicated HomeLink
button pressed down, the LED
briefly flashes fast and then remains
on for 2 seconds; this sequence is
repeated for about 20 seconds.
96
Internal outfits
Programming devices controlled by
alternate code
– Locate the specific setting button by
consulting the user manual of the
system to be controlled. This button
is normally located on the motor
which drives the device.
– Press the button and, in normal
conditions, a LED will illuminate.
WARNING: Normally, after this
operation you have 30 seconds to start
the next one.
– Briefly press the HomeLink button
you have chosen to control the
device;
– press it a second time; when it is
released the operation should be
completed. For some types of
motors, the button might have to be
pressed a third time.
Reprogramming an individual
button
If you wish to program activation of a
new system on an already used
HomeLink button, proceed as follows:
– press and hold the HomeLink button
selected
– after about 20 seconds, the LED P
starts flashing; hold the button
down
– hold the original remote control of
the device to be controlled close to
the HomeLink control panel (0-30
cm)
– press and hold the button on the
original remote control
– if the programming procedure has
been successfully completed, the LED
P will flash faster;
– release both buttons.
The system previously programmed on
Home Link has thus been replaced with
the new programming and is ready to
be used.
This operation has no impact on the
other HomeLink buttons.