Maserati Quattroporte Automatic Owner's Manual page 95

Table of Contents

Advertisement

M139_UM_ing.book Page 95 Friday, September 5, 2008 8:19 AM
Configuration according to the
country of use
The system is normally set to the
operating mode for the country where
the vehicle is sold.
Procedure for selecting the country of
operation:
1) Press and hold buttons M and O;
2) after approx. 20 seconds the LED P
starts flashing, indicating that all
the three programmable channels
have been reset
3) Hold down buttons M and O until
the LED goes off (about 10 seconds)
then release the buttons
4) press buttons M and O again.
5) After one second, press button N;
when it is released, the LED P starts
flashing; the number of flashes
shows the operating mode for the
country (see the table "Countries of
Operation")
6) Press button N when reaching the
number of flashes corresponding to
the relative country.
At the end of the flashing cycle (4
flashes), the flashing sequence restarts
from scratch.
"Countries of Operation" table
No. of LED
Mode
flashes
1
Rest of Europe
2
France
3
United Kingdom
4
Italy
Programming
– press and hold buttons M and O;
– after about 20 seconds, the LED P
starts flashing;
– release the buttons
– hold the remote control for the
device to be controlled close to the
HomeLink control panel (0-30 cm)
– simultaneously press and hold the
button on the hand-held remote
control and one of the three
HomeLink buttons M, N or O;
– if the programming procedure has
been successfully completed, the LED
P will flash faster;
– release the buttons.
Countries covered
A, B, CZ, CY, DK, FIN, D, GBZ, GR, H, IRL,
IS, L, M, NL, N PL, DOM, P, SK, E, S, CH,
FL, ZA, UAE, RCH, EST, LT, SLO, RUS, LV
F, KWT, MC
GB, KWT, SA
I, AUS, HKJ, AND
To program the other buttons, repeat
the operations skipping the first three
steps.
Use
– When the signal of the device to be
activated reaches its operating
range, press the dedicated Home
Link button
– The LED P remains on while the
signal is being transmitted.
The devices controlled through the
HomeLink function can always be
activated using the original remote
controls.
Internal outfits
3
95

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents