Fitting Child Vehicle Seats For 11 Groups 0 And; Fitting Child Seats Type 1 - Maserati Quattroporte Automatic Owner's Manual

M139_UM_ing.book Page 35 Friday, September 5, 2008 8:19 AM
Fitting child vehicle seats for
groups 0 and 0+
To carry children whose weight falls in
the 0 and 0+ groups, the child seat
must be installed facing rearward.
Carefully check that the brackets C are
properly installed in their seatings E.
The child is then secured by the child
seat harness F.
F
E
C
E
D

Fitting child seats type 1

For carrying children whose weight
falls in group 1, the child seat must be
installed facing forward.
For installation, proceed as follows:
– make sure that the release lever D is
in the permanent position
(retracted);
G
D
E
– align the anchoring points E with the
brackets C, then push the seat until
you hear it click in place, which
indicates it is properly secured
– check that the child seat is correctly
locked by trying to move it with
strength; the incorporated safety
mechanisms prevent the child seat
from being improperly fitted if only
one of the attachment fittings is
locked.
– pass the strap G underneath the rear
headrest, and anchor it onto the
child seat backrest and onto the
bracket on the car body.
This way, the child seat is restrained
not only by the brackets C but also by
the vehicle seat belt and by the upper
strap G.
Always refer to the instruction manual
provided with the child seat for fitting
the vehicle seat belts to the said child
seat correctly.
C
Safe transport of children
2
35