System Initialisation - Maserati Quattroporte Automatic Owner's Manual

M139_UM_ing.book Page 147 Friday, September 5, 2008 8:19 AM
Rear control panel
The rear passengers can also interact
with the system using the controls on
the rear control panel.
The rear panel is activated by pressing
button 12 REAR, on the front control
panel.
REAR mode
Pressing the REAR button 12 (relative
LED comes on) will result in the
following:
– the controls/displays on the rear
control panel are enabled
– the parameters set from the panels
are reproduced on the front and rear
displays.
This function is active in both "MONO"
and "DUAL-ZONE" modes.
Pressing the REAR button 12 again
(LED on) will disable the controls on
the rear panel.

System initialisation

Every time the battery is reconnected,
when the vehicle is started, a system
initialisation procedure is required.
This is run by activating the
compressor. Both displays
automatically show the passenger
compartment temperature set at 22 °C
(72 °F).
The system is set up as follows:
– AUTO (automatic operation, the
words FULL AUTO appear on the
display)
– Compressor enabled (the LED on the
button lights up)
– Defrosting/demisting (MAX DEF)
deactivated (the LED on the button is
switched off)
– Heated rear window deactivated
(the LED on the button is switched
off)
– Recirculation controlled by the
automatic system (if active, 'AQS'
will appear on the display)
– the air ventilation and distribution
are set by the system
– REAR deactivated (the LED on the
button is switched off)
4
147
Air conditioning and heating system