Setting The Avc System With The Stand - Sharp Aquos LC-45G1X Operation Manual

Preparation

Setting the AVC System with the stand

How to install the AVC System vertically using the stand unit
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
Stick each spacer to the
1
stand as shown.
Peel each spacer away from the paper
and attach to the four bulging areas
on the stand.
Bulge
Attach the stand using the
4
stand screws as shown.
NOTE
• When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when
standing up directly on the floor or a flat surface as this can result in equipment failure.
LC-45G1X(E)-a
Attach each cushion to
2
the stand as shown.
Peel each cushion
away from the
paper and attach
Stand
to the four areas
spacer
at the bottom.
Bulge
Attaching point
The AVC System installed
vertically with the stand.
Stand screw
9
Fit the stand to the AVC
3
System.
Insert the stand into the AVC
System, making sure that the
thick and thin bulges of the
stand align with the big and
Stand cushion
small holes on the AVC
System.
Attaching point
Hole
04.10.15, 9:58 AM
Bulge
9