Advertisement
USING YOUR CORDLESS FLOOR AND CARPET CLEANER -cont'd
3 T o clean under furniture, use
6 D o not use the unit to pick
the Shark
Backsaver
folding
up pieces of string or fabrics.
®
™
handle. Press the handle
Do not use the unit to clean
release button and apply a bit
tasseled or frayed carpets.
of pressure to bend the handle
forward. (Fig. 7) The Shark
®
Backsaver
™
joint will release
from the locked position to
reach messes under furniture.
(Fig. 8)
4 D o not use the unit to pick up
liquids or clean wet floors.
5 D o not use the unit on
concrete, tar or other rough
surfaces.
EMPTYING THE DUST CONTAINER
Fig. 9
1 T o achieve the best
2 H old the dust container over
performance, empty the dust
a trash can and press the
container after each use. Press
dust container empty button
the dust container release
located on the lower portion of
pedal on the back of the unit
the handle. The trap door will
to remove the No-Touch dust
spring open and release the
container. (Fig. 9)
debris into the trash can.
(Fig. 10)
STORING YOUR CORDLESS FLOOR AND CARPET CLEANER
1 P roperly storing your unit
push down on the handle to fold
will keep it ready to go the
it completely in half. The folding
next time you want to use it.
pivot will audibly click into the
Store the unit in a dry area
bent position. (Fig. 12)
where it won't be exposed to
C AUTION: Any electronic
the elements. For storing in
appliance should not be stored
smaller spaces the handle folds
in or exposed to areas of
in half.
high heat or humidity. Do not
2 F irst press the Backsaver
store the unit close to stoves,
™
release button to bend the
radiators, furnaces or in a
handle 90 degrees, then firmly
bathroom or bathing area.
8
TOLL FREE: 1-800-798-7398
V1950_N_32_ENG_IB_100928.indd 8-9
Fig. 7
Fig. 8
Fig. 10
Fig. 11
3 T o re-insert the dust container,
position it over the unit and
press down gently until it snaps
into place. (Fig. 11)
F or easy insertion into the
base, tip the dust container
slightly forward.
Fig. 12
MAINTENANCE
Fig. 13
3
Fig. 15
C AUTION: Do not clean the unit
REMOVING AND REPLACING THE
while it is charging.
BATTERY
1 O nce a month, wipe down the
NOTE: If uncertain as to how
unit with a dry cloth, including
to remove your battery pack,
the area under the dust
we suggest you take the unit
container. Wipe away any hair,
to a reputable small appliance
fiber or other dirt that may have
service technician to have this
built up in the chamber and on
service performed.
the rotating brush. Do not use
1 P ress the dust container release
any harsh cleaner or chemicals.
pedal with your foot and remove
2 D o not immerse the unit in
the dust container from the unit.
water.
(Fig. 9)
2 T urn the unit upside down. Be
CLEANING THE ROTATING BRUSH
careful not to accidently turn
1 P ress the dust container release
the unit on!
pedal with your foot and remove
3 P ush in the locking tab and lift
the dust container from the unit.
off the battery compartment
(Fig. 9)
cover. (Fig. 15)
2 T urn the unit upside down. Be
4 C arefully lift out the battery
careful not to accidently turn
pack and disconnect the wire
the unit on!
terminals by pulling apart the
3 R emove the brush cover by
wire terminal connectors.
gently forcing it down. (Fig. 13)
Remove the battery pack.
(Fig. 16)
4 R emove all hair, string or fibers
wrapped around the brush
5 C onnect the wire terminal from
bar. Using a pair of scissors,
the unit to the wire terminal
carefully cut anything wound
connector of the new battery
around the brush bar. Avoid
pack and replace the battery
damaging or cutting the bristles.
pack into the unit. Replace the
(Fig. 14)
battery compartment cover.
Fig. 14
Fig. 16
6 F ollow the instructions on page
7 to charge your new battery
pack. Please call customer
service at 1-800-798-7398
if you have any problems
removing the battery pack.
IMPORTANT This appliance
contains Ni-Cd batteries. The
batteries must be recycled
or disposed of in accordance
with local regulations. Please
consult your Yellow Pages or
local recycling center for more
information.
WARNING: Never use ordinary
batteries for replacement as
these may leak and cause
damage. Use only battery pack
XB1918 for replacement.
Ni-Cd BATTERY
MUST BE RECYCLED
OR DISPOSED OF
PROPERLY
www.sharkclean.com
9
28/09/10 4:21 PM
Advertisement
