Table of Contents
Advertisement
Preparation for use
Setting up the device
When installing your device, please read the recommendations and safety notes in the
!
"Safety" manual.
The device should only be set up in the intended orientation, i.e. in a horizontal position.
We recommend that you place your device on a surface with good anti-slip qualities. In
view of the multitude of different finishes and varnishes used on furniture, it is possible that
the rubber or plastic feet of the device will mark the surface they stand on.
Do not expose the device to extreme environmental conditions (see "Technical data").
Protect the device from dust, humidity, and heat.
Make sure that the device is adequately ventilated. Never place the device on a soft
surface (e.g. carpeting, upholstered furniture, bed). This may block the air vents
underneath the device, which could cause damage to the device due to overheating.
Do not stack several devices on top of each other.
Connecting external devices
Read the documentation on the external device before connecting it.
!
With the exception of USB devices, always remove all power plugs before connecting
external devices!
Do not connect or disconnect cables during a thunderstorm.
Always take hold of the actual plug. Never unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting cables
●
Switch off all equipment concerned.
●
Remove all the mains plugs for the equipment concerned from the mains sockets.
●
Plug in the cables at the device and peripheral equipment. Always pay careful attention to the
safety information provided in the "Important notes" chapter and in the "Safety" manual.
●
Plug the data communication cables into the data/telephone network sockets.
●
Insert the mains plugs into earth-protected mains sockets.
Disconnecting cables
●
Switch off all equipment concerned.
●
Remove all the mains plugs for the equipment concerned from the mains sockets.
●
Unplug the data communication connectors from the data/telephone network sockets.
●
Unplug all cables from the device and peripheral equipment.
USB devices are hot-pluggable. This means you can connect and disconnect devices
i
while your operating system is running.
Additional information can be found in the "Connecting external devices to the USB ports"
section and in the documentation for the USB devices.
8
Fujitsu Technology Solutions
Hide quick links:
Advertisement
Table of Contents
