Table of Contents
Advertisement
4.6
MONITOR COMMANDS
The BUFFALO monitor commands are listed alphabetically, by mnemonic, in Table 4-2. Each of
the commands are described in detail following Table 4-2. In most cases the initial single letter of
the command mnemonic or a specific symbol can be used. A minimum number of characters
must be entered to at least guarantee uniqueness from other commands (i.e., MO = MOVE, ME =
MEMORY). If the letter M is entered, BUFFALO uses the first command in Table 4-2 that starts
with M.
Additional terminal keyboard functions are as follows:
(CTRL)A
(CTRL)B
(CTRL)H
(CTRL)J
(CTRL)W
(CTRL)X
(DELETE)
<CR>
1. Execution is restarted by any terminal keyboard key.
2. When using the control key with a specialized command such as (CTRL)A, the
(CTRL) key is depressed and held, then the A key is depressed. Both keys are then
released.
Command line input examples in this chapter are amplified with the following:
BOLD entries are user-entered on the terminal keyboard.
Command line input is entered when the carriage return key <CR> key is depressed.
Typical example of this explanation is:
>MD F000 F100<CR>
M68HC11EVBU/D
Exit transparent mode or assembler
Send break command to host in transparent mode
Backspace
Line feed <lf>
(1)
Wait/freeze screen
Abort/cancel command
Abort/cancel command
Enter command/repeat last command
NOTES
OPERATING INSTRUCTIONS
4-7
Advertisement
Table of Contents
