Table of Contents
Advertisement
After downloading the S-record file, the EVBU may be reset (via S1) to return to 9600 baud
operation. When the EVBU is returned to 9600 baud operation, the terminal emulator must also
be changed back to 9600 baud operation.
4.4.3
Monitor Program
The monitor program (BUFFALO) is the resident firmware for the EVBU, which provides a self
contained operating environment. The monitor interacts with the user through predefined
commands that are entered from a terminal. You can use any of the commands supported by the
monitor.
EVBU contains no hardware to support the host related commands.
(e.g., ACIA, DUART)
A standard input routine controls the EVBU operation while you enter a command line.
Command processing begins only after the command line has been terminated by depressing the
keyboard carriage return <CR> key.
M68HC11EVBU/D
NOTE
OPERATING INSTRUCTIONS
4-5
Advertisement
Table of Contents
