Motorola M68HC11EVBU User Manual page 34

P
4.6.13 Proceed/Continue
P
This command is used to proceed or continue program execution without having to remove
assigned breakpoints. This command is used to bypass assigned breakpoints in a program
executed by the G command.
Refer to example program shown on page 4-16 for the following P
command example. Breakpoints have been inserted at locations
$0105 and $0107 (refer to example on pages 4-16 and 4-17).
Example:
>G 0100<CR>
P-0105 Y-DEFE X-F4FF A-44 B-FE C-D0 S-0047 Breakpoint encountered at
>P<CR>
P-0107 Y-DEFE X-F4FF A-44 B-FE C-90 S-0047 Breakpoint encountered at
>
M68HC11EVBU/D
Proceed/Continue from Breakpoint
NOTE
Start execution at 0100.
0105. Continue execution.
0107.
OPERATING INSTRUCTIONS
4-27