D&R Airlab User Manual page 39

Airlab Master Panel Wiring
RS 232
Connector type:
METER
Connector type:
TAPE 1 OUT STEREO
Connector type:
Level:
TAPE 2 OUT STEREO
Connector type:
Level:
AUX OUT STEREO
Connector type:
Level:
CUE OUT STEREO
Connector type:
Level:
CRM OUT STEREO
Connector type:
Level:
PROGRAM OUTPUTS
Connector type:
Level is:
PHONES OUT STEREO
Connector type:
Level:
Airlab from D&R Phone +31 294 418014, email:
SubD9 Male
1 = CD (Doesn't need to be connected)*
2 = TD
3 = RD
4 = DTR (Doesn't need to be connected)*
5 = gnd
6 = DSR (Doesn't need to be connected)*
7 = RTS (Doesn't need to be connected)*
8 = CTS (Doesn't need to be connected)*
9 = NC
* (Some PC's require connection instead)
SubD9 Female
1 = CRM-right (feeds meter right)
2 = ground
3 = External CUE LED drive
4 = ground
5 = Program right signal
6 = CRM left signal
7 = +18 volt
8 = -18 volt
9 = Program left signal
Cinch
0 dBu/100 Ohm
Cinch
0 dBu/100 Ohm
Cinch
+6 dBu/100 Ohm
Cinch
+6 dBu/100 Ohm
Cinch
+6 dBu/100 Ohm
Male XLR
+6 dBu
Jack
+20dBu/330 Ohm
Pin 1 = ground
Pin 2 = in phase
Pin 3 = out of phase
Tip = Left
Ring = Right
Sleeve = Ground
info@d-r.nl Page 39