Disarming; System Status Chirps - Viper 5901 Owner's Manual

Note:
Bypass Notification does not occur when the system is in Silent
Mode or if the notification chirps have been programmed off by the
installer.

Disarming

If four chirps are heard when disarming the system, then the security
system was triggered in your absence.
If five chirps are heard when disarming the system, the system was
bypassed the intended zone. In either case, the status LED will indicate
which zone was involved (see Table of Zones).
The security system will retain this information in its memory, and chirp
ignition is turned on.
Note concerning low battery alert:
are low the alarm will give an additional chirp when disarming to let
you know its time to change the battery in the remote.

System status chirps

chirps will audibly report the system's status as described below.
Action Number of Chirps
Arm 1
Arm 1 (3-second delay) + 1
Disarm 2
42
When the batteries in the remote
Description
System armed
System armed with bypass notification
System disarmed
© 2008 Directed Electronics. All rights reserved.