Unlocking/Disarming; Disabling The Starter Kill Without A Transmitter - Viper 552 Series Owner's Manual

Viper 552 series remote start keyless entry system owner's guide

Table of Contents

Enlarged version

NOTE: For Passive Mode to be effective, the Failsafe

must be installed.

Unlocking/Disarming

Pressing

for one second disarms the system and unlocks the

doors (if connected). The horn will honk twice (if connected) and

the parking lights will flash twice to confirm disarming of the sys-

tem. The optional Failsafe

tus LED will turn off, unless the system is programmed for Passive

Mode. In Passive Mode, the status LED will flash rapidly when the

system is disarmed. This indicates that the system will re-engage

the starter kill and re-lock the doors (if Passive Locking has been

programmed) in 30 seconds unless the ignition is turned on.

If your remote transmitter is lost or damaged, you can manually

override the starter kill. To do this, you must have the vehicle's

ignition key and know where the Valet

to check with the installer for the location of the Valet

To override the starter kill, turn

the ignition on and press the

Valet

switch within 10 seconds.

The status LED will stop flashing

and the vehicle should start. If it does not start, you may have

waited too long; turn the ignition off and repeat the process.

LOCATION OF VALET

SWITCH_____________________________

2000 Directed Electronics, Inc.

Starter Kill relay

Starter Kill will be deactivated. The sta-

switch is located. Be sure

DRW-35

switch.

Table of Contents