Viper 5901 Owner's Manual page 31

still enabled).
You can still remote start the vehicle after the turbo timer has timed out
and shut off the vehicle. For safety reasons, if a door is opened or if the
transmission mode and does not remote start until the MTS sequence
is re-initiated.
Note: An optional push button can be hard wired to the (-) activation
turbo timer without having to use the remote.
When the vehicle is running follow the procedures listed above, but
instead of pressing the remote, press the push button the appropriate
number of times to activate the remote start (factory setting is for 1
pulse). The remote emits the remote start confirmation tone, after which
ning for the pre-programmed amount of time.
Runtime check
Command
:
Feedback
:
Notes
:
Runtime reset
Command
While the remote start is running, press
:
Feedback
:
Notes
:
© 2008 Directed Electronics. All rights reserved.
While the remote start is running, press
and then Hold for 1.5 seconds.
This feature is only available on the 2way remote.
then .
Remote start ON tones.
Re-starts the remote start runtime counter if remote start
is active. Note: If remote start is not active, the 2-WAY
-
two-times,
one-time and
31