How To Use The Remote Control - Pyle PSBV200BT Owner's Manual

HOW TO USE THE REMOTE CONTROL

1. Battery Installation:
a. Slide and lift up the battery door.
b. Install two "AAA' size batteries (included) into the battery compartment
according to the polarity markings inside battery compartment.
c. Replace the battery door.
2. Effective scope of the remote control
The remote control has an operating range which is less than 16 feet
and at 30 degree angle left or right away from the system.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the
batteries as indicated next to the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together(e.g. Alkaline,
Rechargeable and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time, remove
the batteries to prevent damage or injury from possible battery
leakage.
5. Do not try to recharge batteries which are not designed to be
recharged. They can overheat and rupture.
6. Do not dispose of batteries in fire. Batteries may explode or
leak.
PSBV200BT
STANDBY INPUT
SD USB
30
30
Approx 16 feet
NOTES:
When there is an obstacle between the unit
and the transmitter, the transmitter may not
operate.
When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light
shines on the remote sensor of the unit, the
remote operation may be unstable.
9