Specifications; Placing The Unit - Pyle PSBV200BT Owner's Manual

SPECIFICATIONS

Power Supply----------
Peak RMS Output--------------------------------------------------------------------300W
Input Sensitivity---------------------------------------------------------- 400mV±50mV
S/N(A Weight)----------------------------------------------------------------------
Channel Separated Rate(1KHz)-----------------------------------------------
Woofer Impedance----------------------------------------- -----------------------8 Ohm
Tweeter and full range speaker Impedance----------------------------------4 Ohm
THD(1KHz, 1W, 8Ohm)----------------------------------------------------------
Frequency Response------------------------------------------------------ 20Hz-20KHz
Dimensions(WxDxH)------------------------------------------------- 605x250x120MM
Weight---------------------------------------------------------------------------------5.3KGS
NOTE: Specifications are subject to change for improvement without
prior notice.

PLACING THE UNIT

Take advantage of 3D stereo technology, you can listen to surround
sound without extra speakers. Placing your system as follows, and turn
on BASS +/- or TRE +/- effect by pressing these Buttons on the remote
control, you will get the surround sound effects.
----------------------------------------- AC:100~120V, 50/60Hz
--
4
-
- 80dB
- 40dB
- 0.5%
-
-