Figure 7—XDM4600KIT Wiring Scheme. NOTE for detailed Keypad wiring refer to figure 10
under installing zone keypad section of the manua
Figure 7 shows the system wiring schematic for the Central Controller (XDM46CC), four Zone Keypads (XDM46K) and their
speaker pairs.
How to read the schematic:
• CAT-5 cables are shown connecting the Central Controller to the Zone Keypads and the Door Station.
• 16-gauge, 2-conductor power wire is shown connecting the Central Controller to the Zone Keypads and 18-guage,
2-conductor speaker wire connecting the Zone Keypads to their speakers.
• At the top of the Central Controller, the line going from the Central Controller in the direction of the Expansion
Hub represents the connection cable.
Note:
If the Expansion Hub is accidentally turned off, both the Expansion Hub and
Central Controller will need to be powered down. Then power up both, the
Expansion Hub and Central Controller, effectively rebooting the system.
14
M&S Systems
2861 Congressman Lane
l.
Dallas,Texas 75220
800.877.6631
www.mssystems.com