Installing The Door Station; Installing The Expansion Hub; Figure 11-Door Station Wiring - M&S Systems XDM4600 Owner's Manual

Installing the Door Station

• Run CAT-5 wire from the Door Station to the Central Controller location.
• The recommended height for Door Station rough-in box is 48-inches from the ground to the bottom of the box.
• An ME 3 back box is required for new construction. It is shipped separately.
Figure 11—Door Station Wiring
Figure 11 shows the wiring hookups for the Door Station (DS3B2). The color-coded wires of the Door Station and the CAT-5
cable are matched up and attached with wire nuts.
An ME3 back box is required for the DS3B2 and must be installed at rough in.

Installing the Expansion Hub

The Expansion Hub is available as an optional component. It expands your system to eight zones.
Location Considerations
• DO NOT place anything on top of the Expansion Hub that will interfere with the airflow out of the vents.
• DO NOT place the Expansion Hub near any strong heat source such as a heating vent or a heating element.
• Place the Expansion Hub on top of the Central Controller. Because the Expansion Hub has feet, you can stack it
on top of the Central Controller without blocking airflow. The length of the cable that goes from the Central
Controller to the Expansion Hub is 6-8 inches.
• Place the Expansion Hub within six feet of a household power outlet.
20 M&S Systems 2861 Congressman Lane Dallas,Texas 75220 800.877.6631 www.mssystems.com