Figure 13 - 4-Zone Expansion Hub Wiring - M&S Systems XDM4600 Owner's Manual

How to read the schematic for figure 12 (pg.20):
• The 1x8 power connector attaches to the 16-gauge, 2-conductor wire that provides power to each of the Zone
Keypads. The connector label shows the proper positions. Solid red indicates the location of the positive wires and
striped red indicates the location of the negative wires.
• The four 1x4 connectors attach to two of the four CAT-5 twisted pair wires and carry data between the Expansion
Hub and the Zone Keypads. The unused wires are cut off. The connector label shows the proper position of each
color-coded wire. From right to left, the color code is as follows: green and green/white, orange, orange/white.
Figure 13—4-Zone Expansion Hub Wiring. Figure 13 shows the system wiring for the Expansion
Hub (XDM46EH) and four Zone Keypads (XDM46K) and their speaker pairs.
How to read the schematic for figure 13:
• CAT-5 cables are shown connecting the Expansion Hub to the keypads and the keypads to the local audio source
wall plates. Refer to figure 10 under the installing the zone keypads section of the manual.
• 16-gauge, 2-conductor power wire is shown connecting the Central Controller to the Zone Keypads and 18-guage,
2 conductor speaker wire connecting the keypads to their speakers.
• The line going from the Expansion Hub in the direction of the Central Controller represents the connection cable.
22 M&S Systems 2861 Congressman Lane Dallas,Texas 75220 800.877.6631 www.mssystems.com