Install Batteries; Set Time And Date - M&S Systems XDM4600 Owner's Manual

Install Batteries

1. Remove the battery cover
2. Insert 4 AAA batteries. Follow the diagram to place them in the correct positions.
3. Close the battery cover until it clicks.

Set Time and Date

1. Press the EDIT button, then the TIME/DATE button. These buttons are located on the back of the remote.
Use a paperclip or similar tool to press these buttons. The display on the front of the remote shows SET HOUR.
2. Press VOLUME+ or VOLUME- to select the hour. The remote cycles through a 12 hour clock (AM and PM)
and then a 24 hour clock. A PM shows on the display for PM times. There is no display for AM.
3. Press CH+ and the VOLUME buttons to set the minutes, date, year, and day.
4. Wait a few moments and the remote returns automatically to its normal mode.
Learn Mode
The XDM46R is preprogrammed to control the volume at the Zone Keypads. You must transfer other signals from the
original audio equipment remotes by using Learn mode.
WARNING:
T
HE VOLUME COMMANDS ARE PREPROGRAMMED
FROM YOUR SOURCE REMOTES
1. Press the LEARN button on the back of the Universal remote. Use a paperclip or similar tool to press this button.
The display shows LEARN blinking.
2. Press the device button of the audio source you want to transfer a signal for.
3. Press a storage button. This is the button that will be used to perform the signal you transfer. The word LEARN
stops blinking. The unit is now prepared to accept input from the original remote.
4. Place the original remote so that its infrared beam points at the bottom end of the XDM46R. The two remotes
should be 2-3 inches, or 5-8 centimeters, apart.
5. Press and hold the button on the original remote that contains the signal you want to transfer. When the information
has been transferred, the XDM46R display shows OK. Then the word LEARN starts blinking again.
6. Repeat steps 3-5 until all learning is complete.
7. When you are finished, wait 15 seconds and the XDM46R returns to its normal mode.
E
XAMPLE
To transfer the signal that turns on the DVD player:
1. Press LEARN on the back of the XDM46R.
2. Press the DVD button on the front.
3. Press and hold the POWER button.
4. Point the original DVD remote at the XDM46R and press the POWER button on the original DVD remote.
Hold until the display shows OK.
To use the XDM46R to turn on the DVD player, press DVD, then POWER.
8
.
M&S Systems 2861 Congressman Lane
. D
O NOT LEARN THE VOLUME FUNCTIONS
Dallas,Texas 75220 800.877.6631 www.mssystems.com