Dual Stream 3G Inputs To Separate Sdi Outputs - AJA FS2 Quick Start Manual

12
Dual Stream 3G
Inputs to
Separate SDI
Outputs
The previous workflow showed you how to use Dual Stream 3G in and produce Dual
Stream 3G out. This variation shows you how to input (muxed) Dual Stream 3G and
demux it to produce separate SDI outputs.
The setup is:
• Apply Dual Stream 3G video (Level B—two 1080i59 images) to SDI 1 In.
The parameter settings are:
• Video 1 Input set to SDI 1.
• Output Format set to 1080i59.94.
• Video Output Mode set to Normal.
The menu operations for this workflow are:
1. Press the System button.
2. Select 4 SDI1 3G Detect, and adjust to Auto Detect or Dual Stream.
(Note that Auto Detect uses the SMPTE 352 embedded Format ID data stream to
automatically detect Dual Stream 3G video.)
3. Select 5 SDI2 Input Protect, and adjust to Dual Stream 3G.
4. Press the Video 1 button, select 2 Output Format, and adjust to 1080i59.94.
5. Select the Output button, select 1.1 SDI1 Video Out, and adjust to Processor 1.
6. Press the Video 1 button, select 1 Video 1 In, and adjust as follows:
a. Adjust to SDI1 (display bottom line shows SDI1-1). The SDI 1 Output is now
1080i59.94 stream 1 of the input video.
b. Adjust to SDI2 (display bottom line shows SDI1-2). The SDI 1 Output is now
1080i59.94 stream 2 of the input video.
As you can see, using the ADJUST knob, you can select which stream of the Dual
Stream 3G input video you want to see at the SDI 1 Output.
The two demuxed video streams are also available at the other outputs—SDI 2,
Fiber 1, and Fiber 2 if you switch those outputs to show the desired input stream.