Preparation For Setting Up; Prepare The Housing - Sea&Sea MDX-RX100/? Instruction Manual

Preparation for Setting Up

This product must be used in combination with the optional equipment
(digital camera, port, strobe, accessories etc.) for underwater photography.
In order to set up the equipment, prepare each item correctly.

Prepare the housing

[With the RX-100M2]
• Attach four rear cushion rubbers
(small) on the rear window (four
positions).
Rear cushion rubber (small)
[With the RX-100]
• Attach four rear cushion rubbers
(large) on the rear window (four
positions).
Rear cushion rubber (large)
• Replace the mode dial rubber
(small large).
(small)
• Replace the wheel rubber
(small large).
(small)
CAUTION
Be sure to retain the replaced parts.
The port on this product is built into the housing and thus cannot be removed.
E-7
(large)
The mode dial rubber
should be fitted firmly
in the groove of the
mode pulley.
(large)
Mode dial rubber
Mode pulley
Push it in firmly as far as it will go.
Mode dial rubber
Wheel rubber