Leak Sensor - Sea&Sea MDX-RX100/? Instruction Manual

Leak sensor

The optional leak sensor (46115) can be attached on this product.
<Attaching procedure>
1
Peel off the mount from the
backside of the leak sensor and
attach the sensor to the position
indicated in the figure
Insert the LED in the position
indicated in the figure; then,
bundle the excess cord and fit in
the groove
2
Cut each cord clip by 5 mm as
shown in the figure below, attach
the two clips and pass the
sensor cord through them
CAUTION
Before attaching the optional leak sensor (46115) on this product, be sure to
read the instruction manual for the leak sensor.
LCD Monitor Hood with Lens
The LCD monitor hood holder on this product accepts the LCD monitor
hood with lens (52121).
CAUTION
When attaching LCD monitor hood to the LCD monitor hood holder,
always make sure to refer to and follow the instructions in the
accompanying instruction manual.
5mm
Cord clip
Attaching the Optional Accessories
E-18