Opening And Closing The Housing - Sea&Sea MDX-RX100/? Instruction Manual

Opening and Closing the Housing

Opening and closing the housing is done with the lock knob. Here we
will explain how to open and close the lock knob.
Opening the lock knob
1
Push the tab outward to unlock
as indicated by
the lock knob clockwise as
indicated by
cover from the front case (Fig. 1)
2
Pull the rear case to open
(Fig.2)
CAUTION
Before opening the rear case, make
sure that the housing is completely
dry and free of salt deposits. If you
find any salt deposits, rinse with fresh
water and wipe off water completely
with a soft cloth.
Never turn the knob without pulling
the tab, as it may result in damage
to the knob.
The lock knob only turns up to 90
degrees. The lock knob may become
damaged if it is turned forcibly.
When pulling the tab outward, be
sure to use the tips of your fingers,
not your fingernails.
Never use the tab/lock knob
underwater.
Do not place the housing on desks or other tabletop surfaces with the
rear case opened and the inner side facing down. Be careful as doing so
may cause the projection on the rear case to become deformed or
damaged. (Fig. 3)
When opening the rear case after use in the water, open it carefully not to
let water or sand enter inside the housing.
E-9
, and rotate
to lift the rear
Tab
Fig.1
Fig.2
Fig.3