Husqvarna Automower Operator's Manual page 30

3. Installation
If you intend to bury the boundary wire:
• Make sure to place the boundary wire at least 0.5"
and a maximum of 8" into the ground.
The boundary wire must not be crossed on the path
to and from an island.
Laying the boundary wire in towards the charging
station
The boundary wire can be routed in several different
ways in towards the charging station. The best
alternative is to route the wire completely outside the
charging station, see alternatives 1 and 2 in the
illustration. The wire can also be placed under the
charging station plate as shown in alternative 3 in the
illustration. However, the wire should not be placed
outside alternative 3 because it can then be difficult
for Automower to find the charging station.
When connecting to the charging station, the right
end of the boundary wire should be guided into the
right-hand hole and the cable's left end in the
left-hand hole.
30 Automower from
™
1.
2.
3.
3012-722
3012-671
3012-462