Dell Z9500 Installation Manual page 14

Label
Figure 4. 40GbE Port LEDs (I/O Panel)
1. Port LED
NOTE: In 40GbE mode, the front end ports are "solid green" color in operational state. However, if
the port is configured to work in 10GbE mode, then the front end ports are "solid amber" color in
operational state.
NOTE: The four 10GbE ports split from a single 40GbE port share the same locator LED as the
40GbE port. Use the CLI system location-led interface fortyGigE /tengigabitethernet SLOT/PORT on
command to locate the 10GbE/40GbE port and then press the channel selector button to locate
the corresponding 10GbE port as shown in Figure 3. When port locator functionality is enabled on a
port - the corresponding port LED turns solid blue.
Table 2. 40GbE Port LEDs
Label
Port locator LED
Port link/activity LED
14
LED Color/
Display
• Green solid
LED Color/Display Description
• Off •
• Blue •
• Off •
• Green solid •
• Green blinking •
• Amber solid •
• Amber blinking •
Description
• Traffic on Management Port
No activity
Port locator
No link or interface disabled
40GbE link present and interface enabled
Port has activity
10GbE link present and interface enabled
10GbE port has activity
Hardware Overview