Table of Contents
Advertisement
Dial-out Prefix: It is the number dialed automatically by the system when the FXO
interface diverts a call to the PSTN by VoIP.
FXO Line Default Dial-Out: To set the dial-out number when this FXO line is indicated.
Example:
If PBX extension needs to dial "0" to make a PSTN call, and the FXO are connected to PBX
extension. In this case, the Dial-out prefix should be set to "0". If the PBX requires some delay
time before capturing a line, then the trunk prefix should be set as "0," so that after dialing a 0, it will
pause for 1 second before dialing the destination number. Each comma represents a 1 second
delay. If more delay time is required, simply add more commas. Please note that if a Dial-out
prefix is set, the line won't be able to dial to any PBX extension line (FXS interface does not have a
trunk prefix function). Please refer to Section 6 if required to dial to a PBX extension line and
PSTN concurrently.
Enable FAX: Enable this line to detect if there is a FAX tone to transfer the Codec.
Trunk Hunting Order: To set FXO dial-out mode when there is an incoming call dialed
FXO representative number.
First Idle: The gateway will assign each unassigned call from first FXO line.
Sequential: The gateway will automatically assign the first unassigned call to the first
FXO line. The second FXO line will dial the second unassigned call out. Each line will be
used.
Enable FXO/Trunk Extension Number: Select this function only when FXO receives 2 or
more different PBX or PSTN, or under special circumstances. Users are free to call out
from a desired channel, if assigned. If you register to a Proxy it MUST be checked.
Description:
24
Advertisement
Table of Contents
