A Safe Location For The Heater - Napoleon TERRACE AND PATIO HEATER User Installation And Operation Manual

G
Install a full gas cylinder on the base.
Connect the gas regulator hose to the QCC1
Cylinder valve by turning the knob clockwise
manually.
Do not use a tool, tighten firmly by hand.
Replace cylinder cover.
LEAK TEST
Now that the heater is assembled, for your safety you must perform a leak test of all
connections and hoses.
Mix in a spray bottle equal parts of water and soap.
4. Ensure that the heater gas control knob is fully closed by turning completely
clockwise
5. Open cylinder valve.
6. Apply generously the solution to all connections and hoses.
If you detect bubbles, there is a leak. Close cylinder valve completely. Retighten the
leaking connection and repeat leak test process.
If the leak cannot repaired permanently, close cylinder valve completely and contact
the customer care department at 1 – 866 – 820 – 8686 or a qualified gas technician.

A SAFE LOCATION FOR THE HEATER

CAUTION
When objects are left under a heater in operation, they will be subject to radiant heat
and might be damaged.
● The principal application of this heater is to provide heat to pool and
spa areas, terraces, work areas, etc.
This heater is approved for outdoor use only.
● Provide fresh air ventilation at all times
● Respect minimum clearances to combustibles as shown in figure 11 below.
● Install heater on a leveled, solid and stable ground.
● Do not install in an explosive environment. Keep away from areas from where gas,
vapors or flammable liquids are stored or used.
● In case of high winds, shut-off completely the heater and the cylinder gas valve.
Remove reflector dome.
● Do not move the heater when hot.