Safety Rules For Outdoor Gas Appliance - Napoleon TERRACE AND PATIO HEATER User Installation And Operation Manual

SAFETY RULES FOR OUTDOOR GAS APPLIANCE

1. LP-gas supply cylinder to be used must be constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S. Department of Transportation(DOT) Cylinders,
or Spheres and Tubes for the Transportation of Dangerous Goods, CAN/CSA-B339.
2. The gas supply piping and electrical supply (if applicable) shall be done in accordance
with all local and applicable codes. Only those licensed and qualified in the installation
of gas-fired appliances should be engaged to install this appliance.
3. This gas appliance shall be used outdoors and shall not be used in a building, garage or any
other enclosed area. When used in indoor or enclosed area may cause personal injury or
property damage.
4. If this outdoor gas appliance is not in use, the gas must be turned off at the supply cylinder.
Storage of this outdoor gas appliance indoors is permissible only if the cylinder is
-
disconnected and removed.
- Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
Disconnected cylinders must have threaded valve plugs tightly installed and must not
be stored in a building, garage or any other enclosed area.
5. The pressure regulator and hose assembly supplied with the outdoor gas appliance
must be used.
Replacement pressure regulators and hose assemblies must be those specified by
the manufacturer.
6. The cylinder must be provided with a shutoff valve terminating in an LP-gas supply cylinder
valve outlet specified, as applicable, for Connection No. 510 in the Standard
for Compressed Gas Cylinder Valve Outlet and Inlet Connections, ANSI/CGA-V-1.
7. The cylinder supply system must be arranged for vapor withdrawal.
8. The cylinder used must include a collar to protect the cylinder valve.
This appliance is an infrared transportable heater.
The burner is controlled and adjusted by the gas control knob.
Gas supply is controlled by the valve on the gas cylinder.
The burner is made of stainless steel. Heat diffusion is assisted by the
reflector above.
Technical specification:
• Operating pressure :
• Maximum output :
• Minimum output :
• Gas consumption at HIGH: 1 kg/h
• Approx. weight ;
• Burner orifice size :
11" W.C.
50.000 btu/h
25.000 btu/h
27 kg
1.85 mm