Table of Contents
Advertisement
6.10 Front cabinet shell
a. Remove the top.
b. Remove the control panel.
c. Remove the door.
d. Detach the bellows seal from the front panel.
e. Remove the two screws which secure the door delay device to the
front panel.
f.
Remove the rear shell
g. Detach the circulation hose (if present) from the front shell.
(Fig.43)
h. Replace the rear shell, leaving a gap of 1-2 cm in order to remove
the lateral screws which secure the front shell to the base.
(Fig.44)
i.
Re-position the rear shell completely and re-tighten the screws
which secure the upper cross-member to the rear cabinet shell.
j.
Re-tighten the screws which secure the rear shell to the base.
k. Lay the appliance on its rear panel, preferably on a sheet of
cardboard to protect the surface.
l.
Remove the screws which secure front shell to the base from the
bottom of the appliance. (Fig.42)
m. Remove the screws which secure the upper crosspiece to the
front cabinet shell.
n. Lift the crosspiece and slide the front cabinet shell from the base.
When re-assembling:
Replace the front cabinet shell and check that it is correctly
inserted into the guides in the base.
Fix the screws of the base from the bottom of the appliance.
Place the appliance in the upright position, taking care not to
damage the structure.
Replace the screws which secure the upper crosspiece to the
front cabinet shell.
Remove the screws which secure the upper crosspiece to the rear
cabinet shell.
Slide the rear cabinet shell outwards about two centimeters.
Tighten the lateral screws which secure the front cabinet shell to
the base.
Remove the rear cabinet shell and replace the internal
components removed in previous steps.
Replace the rear shell.
Replace the door, the door delay device, the bellows seal, the
control panel and the top.
The following components are attached to the front cabinet shell:
the support brackets for the feet (using two screws)
the drain filter access panel
It is not necessary to remove the cabinet shell in order to access these components.
2005.11 dmm
60/60
44
599 37 38-46
43
Advertisement
Table of Contents
