Appliance Setup; Remove The Shipping Materials; Remove Shipping Supports; Clean The Appliance - Heatilator RBV4236IH Owner's Manual

14

Appliance Setup

A. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
B. Remove Shipping Supports
• Remove the screw holding the firebox to the shipping
support. See Figure 14.1.
• Squeeze the support to disengage from the lances in
the bottom pan. See Figure 14.2.
• Rotate the support (Figure 14.3), remove and discard.
• Repeat for the other support.
Figure 14.1 Remove Screw from Right Shipping Support
Figure 14.2 Squeeze Support
Figure 14.3 Rotate Support
30 Heatilator • RBV4236/RBV4842 • 4048-210 • Rev S • 6/10
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved

accessories.

WARNING! Risk of Fire and Electric shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Install the Log Assembly
• Base logs have been permanently mounted on the grate
assembly and should not be moved. See Figure 14.4.
Figure 14.4 Base Logs
• Install Y-shaped log on right side of grate using locating
pins to position. See Figure 14.5.
Figure 14.5 Placing Right Top Log