Installing The Holder - Makita VC1310L Instruction Manual

to the SPECIFICATIONS for the relation
between suction force adjusting knob and
the electric power tool input power.
Switching on and off of the connected
electric power tool simultaneously brings the
cleaner switching on and off action. The
cleaner still works for a few seconds even
after the electric power tool is switched off.
After use, disconnect the power tool from
the socket of cleaner.
Switch off the cleaner after use.
Auto-suction stop during suction
operation
WARNING:
Do not use for a long time while the
•
float is at work. Using the cleaner with
its float at work for a long time can
cause overheat, resulting in the cleaner
deformation.
Do not pick up foam or soapy liquid.
•
Picking up foam or soapy liquid can
cause foam to come out of air exit before
the float works. Continuing to using in
this condition may cause an electric
shock and breakage of the cleaner.
The cleaner has a float mechanism that
prevents water from immersing into the
motor when picking up more than a certain
amount of water.
When the tank is full and the cleaner no
longer picks up water, switch off the cleaner
and empty the tank.

Installing the holder

1
011609
When connecting an electric power tool,
secure the power supply cord and hose
using the holders at a 70 cm - 80 cm
distance among the holders that are
1. Holder
6
provided with the cleaner so that the hose is
not entangled by the power supply cord.
Usage of base hook
CAUTION:
Be careful not to pinch your fingers
•
when closing the base hook. Failure
to do so may cause personal injury.
NOTE:
Do not apply an excessive force on the
•
base hook. The excessive force on the
base hook may damage the base hook.
Close the base hook when not in use.
Opening the base hook allows the following
usage.
1. Storing the power supply cord
NOTE:
Do not use
•
connected electric power tool with a
power supply cord wound on the
base hook. Using the cleaner or the
connected electric power tool with
power supply cord may cause damage
the power supply cord.
011597
2. Storing the front cuffs
Front cuffs 22, 24 and 38 can be stored (up
to two at a time.)
011598
the cleaner
1. Power supply
1
cord
2. Base hook
2
1. Front cuffs
1
or a