Assembly - Husqvarna 3002 Owner's Manual

(5) Large Retainer
Springs - 7/16
(2) Smaller Retainer
Springs - 5/16
(1) Anti-Sway Bar
(2) Rear Lift Link
Assemblies
Your new tractor has been assembled at the factory with ex-
ception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 3/4" wrench
(1) 3/4" socket w/drive ratchet
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton .
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
remove.
UNASSEMBLED PARTS
Mower
(1) 3/4 O.D. Washers

ASSEMBLY

Utility knife
Tire pressure gauge
Pliers
Mower Front Wheel
(1) Wheel
(1) Shoulder Bolt
(1) Oil Drain Tube
For Future Use
Keys
(2) Keys
BEFORE REMOVING TRACTOR FROM
SKID
TO CHECK BATTERY (See Fig. 1)
• Lift hood to raised position.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
• For battery and battery cable installation see "RE-
PLACING BATTERY" in the "Service and Adjustments"
section in this manual.
LABEL
5
(1) 1-1/4 O.D. Washer
(1) Locknut
3/8-16
Slope Sheet
Fig. 1