Table of Contents
Advertisement
TO ADJUST SEAT (See Fig. 2):
•
Grasp adjustment handle(A) and pull up, slide seat to
desired po si tion and release adjustment handle.
A
NOTE: You may now roll your tractor off the skid. Follow the
instructions below to remove the tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
•
Raise attachment lift lever to its highest po si tion.
•
Release parking brake by de press ing clutch/brake ped al.
•
Place freewheel control in "trans mis sion dis en gaged"
position (See "TO TRANS PORT" in the Op er a tion
section of this manual).
•
Roll tractor forward off skid.
Continue with the instructions that follow.
ASSEMBLE FRONT WHEEL TO MOWER
(See Fig. 3)
•
Using shoulder bolt, washer and locknut from parts
bag, as sem ble front wheel to mower as shown. Tighten
securely.
ASSEMBLY
Fig. 2
Fig. 3
TO INSTALL MOWER (See Figs. 4-12)
Be sure tractor is on level surface and engage park ing brake.
•
Lower attachment lift lever to it's lowest position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
•
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right.
re mower side suspension arms (A) are pointing
NOTE: Be su
forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under
tractor.
•
FIRST INSTALL ANTI-SWAY BAR (S).
•
From right side of mower, insert anti-sway bar into
hole in transmission bracket (T).
A
6
02965
Fig. 4
A
Fig. 5
T
Fig. 6
S
Advertisement
Table of Contents
